Product List
Membership registration or login is required to view SDS / technical materials.
-
ThreeBond 2921D
- Because this product uses a mixed gas of DME and CO2 whose warming effect is small (GWP: 1 or less), it is much more environmentally-friendly than products that use HFC-134a (GWP: 1430) and HFC-152a (GWP: 124) whose warming effect is large.
- The container of the product has a special absorber inside, which prevents a liquid gas from being sprayed when the product is used upside down.
- The product's prevention of a liquid gas from being sprayed enables the concentration of the gas around the product to be low. Therefore, even if a spark or static electricity occurs, a fire accident can be prevented.
- This prevention also prevents discoloration or deformation of materials used for liquid crystal displays, keyboards, etc. caused by a sprayed liquid gas. This product also prevents breakage of lenses, etc. and a frostbite injury on skin, both of which are
- This product meets the requirements of "Act on Promoting Green Purchasing". When the spray button is just pressed, dust, waste thread, dirt, etc. can be blown off easily. Small wastes in narrow spaces can also be removed easily.
-
ThreeBond 3003J
- Curing in seconds to several tens of seconds under irradiation with UV light
- Low viscosity and excellent workability
- Excellent adhesion on glass, metals, etc.
-
ThreeBond 3003J
- Curing in seconds to several tens of seconds under irradiation with UV light
- Low viscosity and excellent workability
- Excellent adhesion on glass, metals, etc.
-
ThreeBond 3006F
- The resin can cure under irradiation with UV light (200 to 400 nm) only for several to several tens of seconds.
- Excellent heat resistance and chemical resistance.
- The resin forms a rubber-like elastic cured body excelling in conformability to the substrate.
- Biomass raw materials are used as part of the raw materials.
-
ThreeBond 3013B
- Cures in seconds to several tens of seconds under irradiation with UV light
- Colored to visually indicate the state of application
- Excellent adhesion to various substrates
- After curing, it becomes a flexible cured material.
-
ThreeBond 3013Q
- Cures in seconds by exposure to UV light (200 to 400 nm wavelength)
- After curing, retains rubber elasticity over a wide temperature range
- Excellent heat resistance
- Excellent oil resistance
-
ThreeBond 3013Z
- The resin can cure under irradiation of UV light for several to several tens of seconds.
- Portions of the resin not exposed to UV light can be cured by heating.
- After curing, the resin becomes an elastic body excelling in heat resistance and chemical resistance.
- It emits fluorescence when irradiated with black light (365 nm), and it is possible to check whether or not it has been applied.
- Biomass raw materials are used as part of the raw materials.
-
ThreeBond 3015F
- High Tg (glass transition temperature)
- High tensile shear strength
- Low linear expansion coefficient and low cure shrinkage
-
ThreeBond 3017
- Excellent peel strength to films including polyester films
- Excellent peel strength between various plastics and to plastics and metals
- After curing, the resin has flexibility at room temperature.
- Low moisture permeability
- Biomass raw materials are used as part of the raw materials.
-
ThreeBond 3017B
- The resin cures under irradiation of ultraviolet light (wavelength of 200 to 400 nm) in several seconds to several tens of seconds.
- The hardness of the cured resin shows flexibility at normal temperatures.
- It has high peel strength between plastic materials and between plastic and metallic materials
- It has low moisture permeability and water absorption.
- Biomass raw materials are used as part of the raw materials.